Security mode management rights are determined by key fob settings.Key fob events are sent to Ajax apps under the key fob name.👆 Configuration is available only after group mode activation You can select All groups or a single group. Selection of a security group that the key fob manages. Selecting the virtual room to which the device is assigned In this operation mode, the key fob commands are not delivered to the security system. The battery charge level is unacceptably low. Key fobs with firmware version 3.53 and latest do not function when the battery charge level is unacceptably low, do not communicate commands to the hub, and do not notify with LED indication In this case, the key fob commands are delivered to the security system.Ĭontinuous short flashes of red when a key fob with firmware version from 3.18 to 3.52 is used.
Ajax spacecontrol black verification#
The system has not executed the key fob command - integrity verification is enabled in the system and one of the devices is faultyÄŞfter the main indication, the central LED lights up green once and gradually goes outÄŞfter the main indication, the central LED lights up red once and goes out gradually The central LED lights up red for approximately half a second The system has executed the key fob command The central LED lights up green for approximately half a second The central LED lights up green for a few seconds The key fob has been removed from the security system devices Two LEDs next to the button light up green twice. The command has not been delivered as the security system is too far away and cannot receive the command
The LEDs next to the pressed button quickly blink green 4 times The key fob command has been sent over to the security system Two green LEDs next to the pressed button light up once The key fob is not registered with any security system Information about the firmware version is displayed at the very bottom. You can find out the firmware version in the Ajax application → Devices → key fob. Type and color of indication of the key fob display depends on the firmware version of the device. The key fob reports its status only after any button is pressed.
0 kommentar(er)
